△Marcus Zhao
简繁EN
← Back to notes

Journal

A desk lamp and a misplaced washer

I thought the drooping lamp head needed a tighter screw. Then I discovered I had remembered its assembly incorrectly.

My desk lamp had started dropping its head. I would adjust the angle and find the light pointing at the keyboard again a little later. At the weekend I brought out the tools. It is old and scratched, but still works; I did not want to throw it away over a joint.

Taking it apart felt too straightforward to photograph. I laid the screw, washer and knob on the desk, cleaned them and reassembled the joint. It was looser than before. I tightened it again, then stopped. The plastic was beginning to whiten. More force was unlikely to help.

The side I could not remember

The screw was obvious. The small washer was the problem. I remembered it being on the outside, although it would not sit properly there. Once I spread the parts out again, their wear marks offered better evidence than my memory. I matched the contact surfaces slowly before trying the joint.

For now the head stays at the angle I want. I am reluctant to call it repaired until it has had more use. There is also a new pale scratch on the desk, courtesy of the tools.

I know to record the original state before disassembly at work. With my own lamp I decided the job was too simple. It was not a new insight so much as a familiar bad habit finding another object.

After putting the tools away I cleared the papers off the desk. I had meant to spend the afternoon reading a technical piece and no longer felt like it. The light stayed on the page, so I read a little of a novel instead.

Next time I take something apart, I will probably photograph it first. If the lamp droops again, I can use a fixed angle until I find a suitable part. Wanting an old object to work exactly like a new one can sometimes be a refusal by its repairer to stop arguing.